Power-on diagnostics error messages, Troubleshooting 6-3 – Epson Endeavor 468C User Manual
Page 139
The following table lists error messages that may appear
during power-on diagnostics. If you receive an error message,
look it up in the table below; it directs you to the proper
troubleshooting section in this chapter or offers a solution. If
you do
not
see an error message, read the section that covers
your problem.
Power-on diagnostics error messages
Error message
Action
CMOS BATTERY HAS
The CMOS battery is bad. Contact the Epson
FAILED
Connection.
CMOS CHECKSUM
Your CMOS RAM has possibly been corrupted.
ERROR - DEFAULTS
LOADED
Run the SETUP program and check your settings
(see Chapter 2). If your settings are correct, save
them as you exit the SETUP program.
If you see the message again, or if your settings
returned to the factory defaults, contact the
Epson Connection.
DISK BOOT FAILURE,
INSERT SYSTEM DISK
AND PRESS ENTER
The system found no boot device.
First run the SETUP program and check the boot
sequence settings. If the settings are correct and
you are booting from a hard disk drive, see
“Hard Disk Problems.”
If you are booting from a diskette, make sure the
diskette is bootable; then see “Diskette Problems.”
DISPLAY SWITCH IS
SET INCORRECTLY
DIP switch 5 conflicts with the video options in the
SETUP program. See Chapter 4 for correct DIP
switch settings and Chapter 2 for instructions on
running SETUP.
DISPLAY TYPE HAS
CHANGED SINCE
LAST BOOT
The display adapter has been changed. Run
SETUP. See Chapter 2.
Troubleshooting 6-3