Epson Endeavor 468C - Manual (Page 157)

2. Did you install the mouse driver correctly? See your software
manual and the documentation that came with your mouse
for instructions. (Windows installs a mouse driver
automatically.)
3. If you are using a serial mouse, did you disable the built-in
mouse port with SETUP and enable the correct serial port?
See Chapter 2 for instructions.
Memory Module Problems
If you added extra memory to your system by installing SIMMs
and that memory is not operating properly, check the following:
1. If the memory count displayed by the power-on diagnostics
program is incorrect, you may not have installed the
SIMMs correctly. They may be the wrong type of SIMM or
they may not be inserted all the way.
See “Memory Modules (SIMMs)” in Chapter 4 and make sure
you followed all the instructions.
2. Be sure to run the SETUP program after you install or
remove memory modules to automatically update your
memory configuration. See Chapter 2 for instructions.
3. If you still have trouble with your SIMMs, write down any
error messages that appear and contact the Epson
Connection for assistance.
Troubleshooting
6-21