beautypg.com

Starting the setup program – Epson Endeavor 468C User Manual

Page 36

background image

Starting the SETUP Program

To start SETUP, make sure there is no diskette in the diskette

drive; then turn on your computer. (If your computer is already

on, turn it off, wait 20 seconds, and then turn it on again.) After

the self test, you see the following prompt at the bottom of the

screen:

Press if you want to run SETUP

As soon as you see this message, press .

If you do not press within approximately five seconds,

the computer starts loading the operating system and you will

not be able to run SETUP. If this happens, reset the computer

and try again.

When you press [Delete), you’ll see a SETUP menu containing

these options:

1.

Start operating system

2.

Run SETUP

3.

Set Password options

4.

Display system board help

5.

Load default SETUP values

6.

SAVE settings and exit

7.

Exit without saving settings

Type the number of the menu option you want to select, or use

or to move the cursor over the option you want to

select and press As you highlight each menu selection,

you’ll see a description of the option at the bottom of the screen.

Running the SETUP Program

2-3