Defining your own drive type, Setting the primary display type – Epson Endeavor 468C User Manual
Page 42
Defining Your Own Drive Type
If the parameters for your hard disk (listed in its
documentation) do not match any of the types listed in the table
above, you can define your own type. Follow these steps:
1. With the cursor on the drive you are defining, press
until you see type 47.
2. Press to move the cursor into the parameter fields.
3. Enter the appropriate values from the table below.
Drive type options
Heading
Description
Cyln
The number of cylinders on the drive
Head
The number of read/write heads in the drive
WPcom
The precompensation cylinder
Zone
The landing zone (the area on which the computer
parks the heads)
Sec
The number of sectors on the drive
Press after typing each number. Check your drive
documentation for the correct value if SETUP does not
accept a value you’ve typed. SETUP provides the hard disk
size based on the other values you entered.
Setting the Primary Display Type
The Primary display
option lets you define the type of
adapter you are using for your primary display. If you
connected your monitor to the computer’s built-in VGA port,
select VGA/PGA/EGA. If you installed a video card, check the
following table for the correct adapter type.
Running the SETUP Program
2-9