Epson Endeavor 468C - Manual (Page 22)

Follow these steps to connect your VGA monitor to the
computer’s built-in VGA port:
1. Place the monitor and computer so the backs are facing you.
2. There should be two cables provided with your monitor: the
monitor cable (to connect it to the computer) and the power
cable (to connect it to a power source). On most monitors,
the monitor cable is permanently attached to the monitor,
as shown in the following illustration. If your monitor does
not have an attached cable, connect the cable to it now. (See
your monitor manual for instructions.)
3. Align the connector on the monitor cable with the VIDEO port
on the computer; then insert the connector. Be careful not to
bend the pins when inserting it.
Setting Up Your System
1-3