Epson Endeavor 468C User Manual
Page 43
Video display type options
Select
If
VGA/PGA/EGA* You connected your monitor to the built-in VGA port or
you installed a VGA or enhanced graphics adapter
(EGA) card
Color 40x25
You installed an optional color graphics adapter that is
set to 40-column CGA mode
Color 80x25
You installed a color graphics adapter (CGA) or a
multi-mode graphics adapter (MGA) attached to a
color monitor; be sure to set the color/mono switch on
the MGA card to color
Monochrome
You installed a monochrome display adapter (MDA).
an MGA, or a Hercules
®
MGA attached to a
monochrome monitor; be sure to set the color/mono
switch on the MGA card to mono
l
Default setting
For a composite color monitor, such as a color television with
video input, try selecting Color 80x25. If the monitor’s
resolution is poor, run SETUP again and select Color 40x25.
If you have two display adapters of different types, select the
setting for the one you want to be your primary display
adapter. The other one is your secondary adapter.
If you install one type of display adapter card and then change
the adapter (from VGA to CGA or vice-versa), you also may
need to change the setting of DIP switch 5. If you have two
types of cards, set the jumper and DIP switch to match the
adapter controlling your primary display. See Chapter 4 for
instructions on changing jumper settings and the manual that
came with your monitor for additional information.
2-10
Running the SETUP Program