Epson PhotoPC 600 - Manual (Page 37)

The camera’s auto shut-off feature remains in effect
when the camera is connected to your computer, but it
takes place after 5 minutes of inactivity. To turn the
camera back on, you can close and reopen the lens cover,
or you can use any of the software camera controls on
your computer.
Connecting to a PC
Follow these steps to connect the camera:
1. Make sure the camera and your computer are turned
off. Also make sure the LCD monitor is turned off.
2. Locate a serial port on the back of your computer. You
may have two serial ports labeled COM1 and COM2,
or the ports may be labeled with icons. If you have
two serial ports available, use port 1 to connect your
camera.
3. Line up the serial connector on the cable with one of
the serial ports on your computer, and insert the
connector. Then tighten the screws.
4. Open the connector cover on the side of the camera.
serial port on computer
Connector cover
serial cable
(long cable)
3
R Poppy Rev.B/TCAT
A5 size Chapter 3
97/09/18 pass 6
Using PhotoPC 600 with Your Computer 37