SMA SB 240 - Manual (Page 65)

13.2 Decommissioning the Inverter
1.
Danger to life due to electric shock
Do not disconnect the AC connectors under load.
• Disconnect the inverter from all voltage sources (see Section 9, page 48).
2. Release and remove all cables from the inverter.
3. Loosen all screws in the drill holes.
4. Remove the inverter from the wall or profile rail.
5. If the inverter is to be stored or shipped in packaging, pack the inverter, the DC connectors,
and the AC connector. Use the original packaging or packaging that is suitable for the weight
and dimensions of the inverter (see Section 14 "Technical Data", page 66).
6. Dispose of the inverter in accordance with the locally applicable disposal regulations for
electronic waste.
13.3 Decommissioning the Sunny Multigate
1.
Danger to life due to electric shock
• Disconnect the Sunny Multigate from voltage sources (see Section 10, page 50).
2. Release the screw terminals on the Sunny Multigate using a flat-blade screwdriver (blade
width: 3.5 mm).
3. Remove the conductors L and N from both connecting terminal plates.
4. If a network cable is connected, pull the network cable out of the pin connector.
5. Pull the grounding conductor out of both connecting terminal plates.
6. Disassemble the Sunny Multigate:
• If mounted on a top-hat rail, detach the
Sunny Multigate from the top-hat rail. Tilt
the lower edge of the Sunny Multigate
forwards and lift it up and off the top-hat
rail.
• If mounted on the brackets, release the screws with a flat-blade screwdriver (blade
width: 3.5 mm) and remove the Sunny Multigate.
7. If the Sunny Multigate is to be stored or shipped, pack the Sunny Multigate and the AC
connector. Use the original packaging or packaging suitable for the weight and size of the
Sunny Multigate (see Section 14 "Technical Data", page 66).
8. If the Sunny Multigate is to be disposed of, dispose of the Sunny Multigate in accordance with
the locally applicable disposal regulations for electronic waste.
13 Decommissioning SMA Solar Technology AG
Installation Manual 65 SMA-SB240-IA-en-12