HEIDENHAIN TNC 640 (34059x-01) ISO programming - Manual (Page 501)

HEIDENHAIN TNC 640 501
Find function:
„ List of words recently searched for „ Not available „ Available
„ Show elements of active block „ Not available „ Available
„ Show list of all available NC blocks „ Not available „ Available
Starting the find function with the
up/down arrow keys when highlight is
on a block Works with max. 9999 blocks, can be
set via config datum No limitation regarding program length
Programming graphics:
„ True-to-scale display of grid „ Available „ Not available
„ Editing contour subprograms in SLII
cycles with AUTO DRAW ON „ If error messages occur, the cursor is
on the CYCL CALL block in the main
program „ If error messages occur, the cursor is
on the error-causing block in the
contour subprogram
„ Moving the zoom window „ Repeat function not available „ Repeat function available
Programming minor axes:
„ Syntax FUNCTION PARAXCOMP: Define
the behavior of the display and the
paths of traverse „ Available „ Not available
„ Syntax FUNCTION PARAXMODE: Define
the assignment of the parallel axes to
be traversed „ Available „ Not available
Programming OEM cycles
„ Access to table data „ Via SQL commands „ Via FN17/FN18 or TABREAD-TABWRITE
functions
„ Access to machine parameters „ With the CFGREAD function „ Via FN18 functions
„ Creating interactive cycles with CYCLE
QUERY
, e.g. touch-probe cycles in
Manual Operation mode
„ Available „ Not available
Function TNC 640 iTNC 530