HEIDENHAIN TNC 640 (34059x-01) ISO programming - Manual (Page 500)

500
Datum table:
„ Sorting function by values within an
axis „ Available „ Not available
„ Resetting the table „ Available „ Not available
„ Hiding axes that are not present „ Not available „ Available
„ Switching the list/form view „ Switchover via split-screen key „ Switchover by toggle soft key
„ Inserting individual line „ Allowed everywhere, renumbering
possible after request. Empty line is
inserted, must be filled with zeros
manually „ Only allowed at end of table. Line with
value 0 in all columns is inserted
„ Transfer of actual position values in
individual axis to the datum table per
keystroke „ Not available „ Available
„ Transfer of actual position values in all
active axes to the datum table per
keystroke „ Not available „ Available
„ Using a key to capture the last
positions measured by TS „ Not available „ Available
FK free contour programming:
„ Programming of parallel axes „ With X/Y coordinates, independent of
machine type; switchover with
FUNCTION PARAXMODE „ Machine-dependent with the existing
parallel axes
„ Automatic correction of relative
references „ Relative references in contour
subprograms are not corrected
automatically „ All relative references are corrected
automatically
Handling of error messages:
„ Help for error messages „ Call via ERR key „ Call via HELP key
„ Switching the operating mode while
help menu is active „ Help menu is closed when the
operating mode is switched „ Operating mode switchover is not
allowed (key is non-functional)
„ Selecting the background operating
mode while help menu is active „ Help menu is closed when F12 is used
for switching „ Help menu remains open when F12 is
used for switching
„ Identical error messages „ Are collected in a list „ Are displayed only once
„ Acknowledgment of error messages „ Every error message (even if it is
displayed more than once) must be
acknowledged, the Delete all
function is available „ Error message to be acknowledged
only once
„ Access to protocol functions „ Log and powerful filter functions
(errors, keystrokes) are available „ Complete log without filter functions
available
„ Saving service files „ Available. No service file is created
when the system crashes „ Available. A service file is
automatically created when the
system crashes
Function TNC 640 iTNC 530