Tool length: q114, Coordinates after probing during program run – HEIDENHAIN TNC 640 (34059x-01) ISO programming User Manual
Page 278

278
Programming: Q Parameters
8.1
1
Pr
eassigned Q P
a
ra
met
e
rs
Unit of measurement for dimensions in the
program: Q113
During nesting with PGM CALL, the value of the parameter Q113
depends on the dimensional data of the program from which the other
programs are called.
Tool length: Q114
The current value for the tool length is assigned to Q114.
Coordinates after probing during program run
The parameters Q115 to Q119 contain the coordinates of the spindle
position at the moment of contact during programmed measurement
with the 3-D touch probe. The coordinates refer to the datum point
that is active in the Manual operating mode.
The length of the stylus and the radius of the ball tip are not
compensated in these coordinates.
Dimensional data of the main program
Parameter value
Metric system (mm)
Q113 = 0
Inch system (inches)
Q113 = 1
The TNC remembers the current tool length even if the
power is interrupted.
Coordinate axis
Parameter value
X axis
Q115
Y axis
Q116
Z axis
Q117
4th axis
Machine-dependent
Q118
5th axis
Machine-dependent
Q119