HEIDENHAIN TNC 640 (34059x-01) ISO programming - Manual (Page 159)

HEIDENHAIN TNC 640 159
5.2 T
ool D
a
ta
Tool usage test
In order to run a tool usage test, the complete plain-language program
must have been simulated in the Test Run mode.
Applying the tool usage test
Before starting a program in the Program Run mode of operation, you
can use the TOOL USAGE and TOOL USAGE TEST soft keys to check
whether the tools being used in the selected program are available and
have sufficient remaining service life. The TNC then compares the
actual service-life values in the tool table with the nominal values from
the tool usage file.
After you have pressed the TOOL USAGE TEST soft key, the TNC
displays the result of the tool usage test in a pop-up window. To close
the pop-up window, press the ENT key.
The TNC saves the tool usage times in a separate file with the
extension pgmname.H.T.DEP. The generated tool usage file contains
the following information:
The tool usage test function must be enabled by your
machine manufacturer. Refer to your machine manual.
Column Meaning
TOKEN „ TOOL : Tool usage time per TOOL CALL. The
entries are listed in chronological order.
„ TTOTAL : Total usage time of a tool
„ STOTAL : Call of a subprogram; the entries are
listed in chronological order
„ TIMETOTAL : The total machining time of the
NC program is entered in the WTIME column.
In the PATH column the TNC saves the path
name of the corresponding NC programs.
The TIME column shows the sum of all TIME
entries (without rapid traverse). The TNC
sets all other columns to 0
„ TOOLFILE : In the PATH column, the TNC
saves the path name of the tool table with
which you conducted the Test Run. This
enables the TNC during the actual tool
usage test to detect whether you
performed the test run with the TOOL.T.
TNR Tool number (–1: No tool inserted yet)
IDX Tool index
NAME Tool name from the tool table
TIME Tool-usage time in seconds (feed time)
WTIME Tool-usage time in seconds (total usage time
between tool changes)