HEIDENHAIN TNC 640 (34059x-01) ISO programming - Manual (Page 162)

162 Programming: Tools
5.2 T
ool D
a
ta
In the new view, the TNC presents all tool information in the following
four tabs:
„ Tools :
Tool specific information
„ Tool pockets :
Pocket-specific information
„ Tooling list :
List of all tools in the NC program that is selected in the Program
Run mode (only if you have already made a tool usage file, see "Tool
usage test", page 159)
„ T usage order :
List of the sequence of all tools that are inserted in the program
selected in the Program Run mode (only if you have already made a
tool usage file, see "Tool usage test", page 159)
You can edit the tool data only in the form view, which you
can activate by pressing the FORM FOR TOOL soft key or
the ENT key for the currently highlighted tool.