HEIDENHAIN TNC 640 (34059x-01) ISO programming - Manual (Page 330)

330 Programming: Multiple Axis Machining
1
1
.2 The PLANE F
unction: Tilting the W
o
rk
ing Plane (Sof
tw
ar
e Option 1)
Input parameters
U X component of base vector? : X component BX of the
base vector B (see figure at top right). Input range:
-9.9999999 to +9.9999999
U Y component of base vector? : Y component BY of the
base vector B (see figure at top right). Input range:
-9.9999999 to +9.9999999
U Z component of base vector? : Z component BZ of the
base vector B (see figure at top right). Input range:
-9.9999999 to +9.9999999
U X component of normal vector? : X component NX of
the normal vector N (see figure at center right). Input
range: –9.9999999 to +9.9999999
U Y component of normal vector? : Y component NY of
the normal vector N (see figure at center right). Input
range: –9.9999999 to +9.9999999
U Z component of normal vector? : Z component NZ of
the normal vector N (see figure at lower right). Input
range: –9.9999999 to +9.9999999
U Continue with the positioning properties (see
"Specifying the positioning behavior of the PLANE
function" on page 336)
NC block
Abbreviations used
5 PLANE VECTOR BX0.8 BY-0.4 BZ-0.42 NX0.2 NY0.2 NZ0.92 ..
Abbreviation Meaning
VECTOR Vector
BX, BY, BZ Base vector: X, Y and Z components
NX, NY, NZ Normal vector: X, Y and Z components