beautypg.com

Cycle run – HEIDENHAIN iTNC 530 (340 49x-06) Cycle programming User Manual

Page 383

background image

HEIDENHAIN iTNC 530

383

15.12 D

A

TUM A

T

CENTER OF 4 HOLES (Cy

c

le 41

8, DIN/ISO: G41

8

)

15.12 DATUM AT CENTER OF 4

HOLES (Cycle 418, DIN/ISO:
G418)

Cycle run

Touch Probe Cycle 418 calculates the intersection of the lines
connecting opposite holes and sets the datum at the intersection. If
desired, the TNC can also enter the intersection into a datum table or
preset table.

1

Following the positioning logic (see “Executing touch probe
cycles” on page 318), the
TNC positions the touch probe at rapid
traverse (value from MP6150) to the center of the first hole

1

.

2

Then the probe moves to the entered measuring height and
probes four points to find the first hole center.

3

The touch probe returns to the clearance height and then to the
position entered as center of the second hole

2

.

4

The TNC moves the touch probe to the entered measuring height
and probes four points to find the second hole center.

5

The TNC repeats steps 3 and 4 for the holes

3

and

4

.

6

Finally the TNC returns the touch probe to the clearance height and
processes the determined datum depending on the cycle
parameters Q303 and Q305 (see “Saving the calculated datum”
on page 344).
The TNC calculates the datum as the intersection of
the lines connecting the centers of holes

1

/

3

and

2

/

4

and saves the

actual values in the Q parameters listed below.

7

If desired, the TNC subsequently measures the datum in the touch
probe axis in a separate probing.

X

Y

1

2

3

4

Parameter number

Meaning

Q151 Actual

value

of

intersection point in

reference axis

Q152

Actual value of intersection point in
minor axis

This manual is related to the following products: