HEIDENHAIN iTNC 530 (340 49x-06) Cycle programming - Manual (Page 14)

14
New Cy
cle F
unctions of Sof
tw
a
re
340
49x
-06
New Cycle Functions of Software
340 49x-06
„ New Cycle 275 "Trochoidal Contour Slot"(see “TROCHOIDAL SLOT
(Cycle 275, DIN/ISO: G275)” on page 205)
„ In Cycle 241 "Single-Fluted Deep-Hole Drilling" it is now possible to
define a dwell depth (see “SINGLE-FLUTED DEEP-HOLE DRILLING
(Cycle 241, DIN/ISO: G241)” on page 98)
„ The approach and departure behavior of Cycle 39 "Cylinder Surface
Contour" can now be adjusted (see “Cycle run” on page 230)
„ New touch probe cycle for calibration of a touch probe on a
calibration sphere (see “CALIBRATE TS (Cycle 460, DIN/ISO:
G460)” on page 458)
„ KinematicsOpt: An additional parameter for determination of the
backlash in a rotary axis was introduced (see “Backlash” on page
473)
„ KinematicsOpt: Better support for positioning of Hirth-coupled axes
(see “Machines with Hirth-coupled axes” on page 469)