HEIDENHAIN iTNC 530 (340 49x-06) Cycle programming - Manual (Page 294)

294 Cycles: Coordinate Transformations
1
1
.9 W
O
RKING PLANE (Cy
c
le 1
9
, DIN/ISO: G80, Sof
tw
a
re
Option 1)
Automatic positioning of rotary axes
If the rotary axes are positioned automatically in Cycle 19:
„ The TNC can position only controlled axes
„ In order for the tilted axes to be positioned, you must enter a feed
rate and a setup clearance in addition to the tilting angles, during
cycle definition.
„ Use only preset tools (the full tool length must be defined).
„ The position of the tool tip as referenced to the workpiece surface
remains nearly unchanged after tilting.
„ The TNC performs the tilt at the last programmed feed rate. The
maximum feed rate that can be reached depends on the complexity
of the swivel head or tilting table.
Example NC blocks:
10 L Z+100 R0 FMAX
11 L X+25 Y+10 R0 FMAX
12 CYCL DEF 19.0 WORKING PLANE Define the angle for calculation of the compensation
13 CYCL DEF 19.1 A+0 B+45 C+0 F5000 SETUP50 Also define the feed rate and the clearance
14 L Z+80 R0 FMAX Activate compensation for the spindle axis
15 L X-8.5 Y-10 R0 FMAX Activate compensation for the working plane