HEIDENHAIN SW 688945-03 - Manual (Page 556)

556 Organization mode of operation
8.3 T
ransf
er
Creating a data backup file
A data backup performs the following steps:
 Copies the program files to the transfer folder.
 NC main programs
 NC subprograms (with graphics)
 Cycle programs
 ICP contours
 Creates a parameter backup and copies all backup files from "\para"
and "\table" to the project folder. (PA_Backup.zip, TA_Backup.zip)
 Creates a tool backup file and copies all tool backup files from "\tool"
to the project folder (TO_Backup.zip).
 Service files are not created and copied.
Data backup selection
Press the soft key and enter the login code.
Press the Transfer soft key.
Open the data backup transfer.
Soft keys for data backup
Starts backing up the data to a
complete transfer folder.
 Existing files will be overwritten without a confirmation
prompt.
 To cancel the data backup, press the Cancel soft key.
The backup process stops as soon as the currently
running partial backup is completed.