HEIDENHAIN SW 688945-03 - Manual (Page 302)

302 Teach-in mode
4.8 Milling cy
cles
Slot, axial
Select milling
Select slot, axial
This cycle mills a slot on the face of the workpiece. The slot width
equals the diameter of the milling cutter.
Type of machining for technology database access: Milling
Parameter combinations for the position and orientation of the slot:
 X1, C1
 L, A1
Cycle parameters
X, Z
Starting point
C Spindle angle (C-axis position)
X1 Slot target point in X (diameter value)
C1 Angle of slot target point (default: spindle angle C)
L Slot length
A1 Angle to X axis (default: 0)
Z1 Milling top edge (default: starting point Z)
Z2 Milling floor
P Infeed depth (default: total depth of one infeed)
FZ Approach feed (infeed rate) (default: active feed rate)
SCK Safety clearance (see page 124)
G14 Tool change point (see page 124)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T
MFS M at beginning: M function that is executed at the
beginning of the machining step
MFE M at end: M function that is executed at the end of the
machining step
WP Displays which workpiece spindle is used to process the
cycle (machine-dependent)
 Main drive
 Opposing spindle for rear-face machining