HEIDENHAIN SW 688945-03 - Manual (Page 473)

HEIDENHAIN CNC PILOT 620/640 473
6.16 Loading existing cont
ours
Activate the ICP editor.
Press the Contour list soft key. The ICP editor
opens the window "Selection of ICP contours."
Press the Next file type soft key until the DXF
contours are displayed (see file extension "*.DXF").
Select the file.
Open the selected file.
Select the DXF layer.
Load the selected contour.
 Blank or finished part contour: Supplement or adapt the
contour, if necessary.
 C-axis or Y-axis contour: Complete the reference data.