HEIDENHAIN SW 688945-03 - Manual (Page 130)

130 Teach-in mode
4.3 Single cut cy
cles
Approaching the tool change position
Call the single-cut menu
Select rapid traverse positioning
Activate the T-Change approach soft key
The tool moves at rapid traverse from the current position to the tool
change position (see page 124).
After reaching the tool change position, the control switches to the
tool indicated in "T."
Cycle parameters
G14
Sequence (default: 0)
 0: Simultaneous (diagonal path of traverse)
 1: First X, then Z direction
 2: First Z, then X direction
 3: X direction only
 4: Z direction only
T Turret pocket number
ID Tool ID number
MT M after T: M function that is executed after the tool call T
MFS M at beginning: M function that is executed at the
beginning of the machining step
MFE M at end: M function that is executed at the end of the
machining step
WP Displays which workpiece spindle is used to process the
cycle (machine-dependent)
 Main drive
 Opposing spindle for rear-face machining