HEIDENHAIN SW 688945-03 - Manual (Page 240)

240 Teach-in mode
4.5 Recessing cy
cles
ICP recess turning, radial finishing
Call the recessing cycles
Select recess turning
Select recess turning, radial ICP
Press the Finishing run soft key
The cycle finishes the contour area defined by the ICP contour section
(see also "Recess turning" on page 220). At the end of the cycle, the
tool returns to the starting point.
With oversizes I, K for the workpiece blank, you define
the material to be machined during the finishing cycle. For
this purpose, enter the oversizes for recess turning,
finishing.
Cycle parameters
X, Z
Starting point
FK ICP finished part: Name of the contour to be machined
RB Depth compensation
I, K Oversize X, Z
SX, SZ Cutting limits (see page 124)
G14 Tool change point (see page 124)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
G47 Safety clearance (see page 124)
MT M after T: M function that is executed after the tool call T