Grass Valley T-POV Bidirectional Robotic User Manual
Page 75
69
T-POV
User Guide
BOPT
Sequence starts with BOPT to indicate the optical signal strength at the
Base Station
-9
Indicates that the signal strength being received at the Base Station is -9
dBm
This display cycle repeats until interrupted by the BASE Rx/DIM button. . A
quick push of the BASE Rx/DIM button returns to the COPT mode A longer
push (approximately 5 seconds) advances to DIAG mode.
DIAGNOSTIC MODE Power (POWR)
Holding the SELECT button for approximately five seconds advances to the First
diagnostic mode, which is POWR status. This mode cycles through the following
sequence and may start at any point in the cycle.
LBUS
Indicates that the LBUS controller board is being measured
POWR
Indicates the display is in the POWER sub-mode
OK
Indicates that the item is in an OK State
UBUS
Indicates that the UBUS controller board is being measured
POWR
Indicates the display is in the POWER sub-mode
OK
Indicates that the item is in an OK State
OBOX
Indicates that the Audio Interface Box controller board is being measured -
applicable to 324 model
POWR
Indicates the display is in the POWER sub-mode
OK
Indicates that the item is in an OK State
MAIN
Indicates that main Portable Unit controller board is being measured
POWR
Indicates the display is in the POWER sub-mode
OK
Indicates that the item is in an OK State
DIAGNOSTIC MODE Microcontroller Board Revision Version (REV)
A quick push of the SELECT button from PWR mode advances to the REV mode. This
mode displays the microcontroller firmware revision of every board in the Portable Unit.
This mode cycles through the following sequence and may start at any point in the cycle.
REV
Indicates that mode is REV
OBOX
Indicates the OBOX microcontroller board is revision is being queried -
applicable to and 324 model
REVD
Indicates that the REV for the Audio Interface Box board is Revision "D" -
Your revision may differ
REV
Indicates that mode is REV
MAIN
Indicates the BASE microcontroller board is revision is being queried
REVD
Indicates that the REV for the BASE Portable Unit controller board is
Revision "D" - Your revision may differ
REV
Indicates that mode is REV
UBUS
Indicates the UBUS microcontroller board is revision is being queried
Readout
Portable Unit Digital Display Activity Explanation