Grass Valley T-POV Bidirectional Robotic - Manual (Page 66)

60
Connecting the T-POV System
Connections to the T-POV Camera Unit
4 Ethernet Connector - 10Bt/100Bt capable
Designed to carry IP traffic data between the Base Station and the Camera Unit.
Can be used to control Ethernet based Camera and Pan & Tilt equipment. Also a
laptop PC or other device such as a Wireless Access Point can be connected to
the Production Environment IP network.
Applies to T-POV 324
6 VBS In
BNC Connector: carries SD Analog video from the Camera Unit to the Base
Station. Typically this will feed a Camera SD menu monitor feed.
Applies to T-POV 324
7 SDI Out A & B
BNC Connector: typically used to send HD return video to the camera (ex.:
program or aux bus out from the Production Switcher).
Applies to T-POV 324
9 DATA 1/2/3/4
DB26: 26 Pin data connector. Used for a variety of serial connections or GPI/Tally
connections. The Camera Control Unit and Pan & Tilt Control is one such data
connection.
Applies to T-POV 324
10 Audio
DB25: 25 Pin connector. Connector follows the Tascam TDIF standard. Up to four
channels of line level audio in and out can be connected.
Applies to T-POV 324
11 Power In
Connect a standard 12V DC ADAP power source (4 Pin).
Applies to all models that have external power.
12 & 14 Fiber Connector
Connect the fiber connector from the Fiber Cable connected to the Camera Unit.
The type of fiber connector depends on whether the system is 12 Volt or
internally powered.
Applies to all models
13 Power Out
Provides a standard 12V DC power source (4 Pin). Total power available including
that used by Camera Unit is 95 Watts.
Applies to all models that have external power.
Item Description