Grass Valley T-POV Bidirectional Robotic - Manual (Page 12)

6
About the T-POV Bidirectional Robotic Camera System
Safety and Fiber Optic Systems
Safety and Fiber Optic Systems
Optical Fiber Safety
To prevent damaging your eyes, never look directly into the end of the optic fiber while
either end of the system is operating.
Always use cable connector caps when the Fiber Optic cables are not connected. This
protects the connector from damage and the unlikely event of exposure to an operating
optical link. Keeping the caps in place when the connectors are not in use will prevent dirt
and dust from entering the connector and degrading the performance of the optical link
Power Fuses
The T-POV Powered Base Stations are equipped with Dual Cartridge fuses located next to
the AC Power receptacle at the left rear of the unit.
NEVER operate a T-POV Powered Base Station without properly installed and rated fuses.
Severe electrical and heat damage to the equipment could result, as well as personal injury
or death.
T-POV-324-R4-2-CA-ST2-12V 324 1 RU Dual Base Station Rack Mount external
power with 2 ST connectors
T-POV-324-R4-2-CA-ST4-12V 324 1 RU Dual Base Station Rack Mount external
power with 4 ST connectors
T-POV-324-MML-CA-ST1-12V 324 Single Base Station Mini-Mussel Shell external
power with 1 ST connector
T-POV-324-MML-CA-ST2-12V 324 Single Base Station Mini-Mussel Shell external
power with 2 ST connectors
T-POV-324-MMH-CA-304M-95V 324 Single Base Station Mini-Mussel Shell internal
power with 304M connector
Part No. Short Description