Grass Valley T-POV Bidirectional Robotic - Manual (Page 63)

57
T-POV
User Guide
Connections to the T-POV Base Station
This section provides details on both the connectors and signal types that can be applied to
the T-POV Base Stations(T-POV 301 and 324 are illustrated). In the list of connections, it is
noted which connections are applicable to the various T-POV models.
Fig. 5-4: T-POV Base Station
T-POV 301 Base Station Connectors T-POV 324 Base Station Connectors
T-POV Powered Base Station Connectors
Item Description
1 & 15 Power In
Connect a standard 12V DC ADAP power source (4 Pin) or a standard 3
conductor AC Cable (IEC Plug) 100-240V 50/60 Hz
Applies to all models depending on power type.
2 12V Terminal Block
The bare wire connector can be used in place of the ADAP power connection in
installations that have 12V power distributed as part of their infrastructure. Do
not use this at the same time as the ADAP power connection.
Applies only to 12 Volt models - does not apply to AC powered types
3 MON - RJ45 Network Type Connection
For Future Use
Applies to all models
4 & 16 Fiber Connector
Connect the fiber connector from the Fiber Cable connected to the Camera
Unit. The type of fiber connector depends on whether the system is 12 Volt or
internally powered.
Applies to all models.
Note: Power to the Base Unit (and the Camera Unit) must be turned off when
connecting the Camera Remote Control Panel. Connecting with the power on
can seriously damage your equipment.