Grass Valley T-POV Bidirectional Robotic - Manual (Page 22)

16
System Overview
Power options with the T-POV
Power options with the T-POV
The T-POV Robotic Camera Link System has two methods of power for both the Base
Station and the Camera Unit. The Base Station can be powered externally by a 12 Volt
power supply (ADAP-AC-04 is recommended), which will work across a 100-240VAC range.
The Base Station can also be powered with an internal AC power supply. This power supply
provides power to a single Link unit in the Base Station and also provides power down the
Hybrid Fiber Link cable to the Camera Unit.
The externally powered Base Station requires only one power supply regardless of the
number of Camera Link units installed.
The externally powered Camera Unit can be powered by a 12 Volt Power supply, such as the
ADAP-AC-04. The Camera Unit can also be equipped with a 12 Volt battery mount to
provide operation independent of the AC mains or as an on-board power backup. Mounts
for Anton Bauer or V-Mount type batteries are available.
Fig. 2-16: ADAP-AC-04 Power Supply?
Part Number
ADAP-AC-04
Supplied with 4PIN
XLR/A4F connector