Mediaframe stage – Grass Valley NewsBrowse Desktop Browsing System Installation v.3.1 User Manual
Page 61

April 27, 2006
NewsBrowse Installation and Configuration Guide
61
MediaFrame stage
NOTE: The NewsBrowse server must host the NTFS MDI.
The ASK settings page registers the logical names for the MDIs and Encoders
required by your NewsBrowse system with the ASK software component, which runs
on the NewsBrowse server.
Note the following distinction when entering “Hostname or IP”:
• For MDIs (K2, Profile, M-Series, News, Proxy, NTFS, Archive) enter the
hostname of the machine hosting the MDI software component, rather than the
hostname of the machine being managed by the MDI.
• For Encoders (Advanced Encoder, SmartBin Encoder, Single-channel Encoder)
you enter the hostname of the encoder itself.
NewsEdit
News
As per
convention.
Hostname of the machine hosting
the News MDIs. This must be the
DSM.
Leave field
blank.
Correct port
number is
automaticall
y entered on
“Add MDI”.
Refer to
“Ports and
services
mapping”
on page 40
to verify.
NTFS storage on
Windows machines
NTFS
NTFS1, as per
convention.
NewsBrowse server hostname, as
the server is the required NTFS
MDI host.
Single-channel
encoder
Single
Channel
Encoder
As per
convention.
Single-channel encoder hostname
Advanced encoder
Advanced
Encoder
Advanced encoder hostname
Proxy
Proxy
PROXY1, as
per
convention.
Hostname of the machine hosting
the Proxy MDI. Typically the
MDI server.
Archive device
… Archive
ARCHIVE1,
as per
convention.
Hostname of the machine hosting
the archive MDI
SmartBin Encoder
SmartBin
Encoder
As per
convention.
SmartBin encoder hostname
a.
For a K2 Storage System, the MDI manages one of its connected K2 Media Clients. As per convention, name the MDI for the K2 Storage
System.
b.
Enter only one Profile per Open SAN. As per convention, name the MDI for the Open SAN, rather than for the Profile.
When you add an
MDI or Encoder
logical name for
this type of
machine/device…
Select “MDI/
Encoder
Type”…
Enter “MDI/
Encoder
Name”…
Enter “Host Name or IP”…
Enter
“Port”…
Comments