Grass Valley Network Attached Storage System Serial ATA Network User Guide v.1.0.04 - Manual (Page 47)

Chapter 3 Software Setup
46 Digital News Production
Running the Setup Wizard
The rest of this chapter describes how to complete the setup and initial
configuration of NewsShare NAS. Refer to the “Worksheet” on page 40 to
determine what values to enter in the fields.
After setup is complete, you can reconfigure any part of NewsShare NAS at any
later time. Setup takes less than half an hour.
NOTE: Changes do not take effect until you reboot this software. At
the end of Setup, you will be asked to reboot.
Setting Up Network Ports
If NewsShare NAS is not attached to an existing network, you can accept all the
default values for the network configuration by clicking on Next until you reach
the Password window.
If NewsShare NAS is attached to a pre-existing network, reconfigure
NewsShare NAS network ports to work in your environment. As NewsShare
NAS starts up, it determines if the system has one or two server nodes and
displays one of these windows:
• “Configuring Dual Node Network Ports” on page 46.
• “Configuring Single Node Network Ports” on page 49.
Configuring Dual Node Network Ports
The Network Port Configuration window lets you view and modify the network
port configuration for a dual node NewsShare NAS system. The window
appears after you initially login to NewsShare NAS, or by choosing
Network |
Configure Network Ports . Enter the IP address that attaches NewsShare NAS
to the existing network. (If NewsShare NAS is not attached to an existing
network, do not change the values on this window.)