Chapter 3: software setup, Chapter 3, Software setup – Grass Valley Network Attached Storage System Serial ATA Network User Guide v.1.0.04 User Manual
Page 40
Digital News Production
39
Chapter
3
Software Setup
This chapter describes how to begin configuring the network, using NewsShare
NAS software. Follow the steps listed below.
1. The workstation must be on the same network as NewsShare NAS. Make
sure you have an Ethernet hardware path that does not require a router to the
NewsShare NAS server.
2. To ensure that the cabling is correct, ping NewsShare NAS.
3. Fill in the worksheet on page 40.
4. Review the information found in “Using the Software” on page 42.
5. Power up NewsShare NAS. On a client PC or workstation, open a Web
browser and enter the address of the NewsShare NAS software.
6. Read and accept the license agreement, as shown on page 44.
7. Enter the initial password, as shown in “Entering Initial Password” on page
8. Run the Setup wizard, which guides you through a few essential functions.
The components of Setup are described on page 46.
9. Save the new settings and reboot the software, as described in “Save and