Grass Valley Network Attached Storage System Serial ATA Network User Guide v.1.0.04 - Manual (Page 119)

Chapter 9 Network Administration
118 Digital News Production
Step D. Saving the Configuration
After entering changes, click Save . You are asked if you want to reboot
immediately or wait until later. (You might want to check some values or status
before rebooting.).
NOTE: Changes do not take effect until you reboot through this
software.
Configuring Single Node Network Ports
From the Network menu, choose Network Port Configuration . For details,
refer to Configuring the Node in “Configuring Single Node Network Ports” on
page 49. (If NewsShare NAS is not attached to an existing network, do not
change the values on this window.)
Step A. Configuring the Node
1. (Optional) Enable jumbo frames. Click on the check box to enable jumbo
frames (or to disable them when already enabled). Using standard frames,
the packets sent through the network are 1.5K. Using jumbo frames, the
packets sent through the network are 9K. Jumbo frames improve
performance.
NOTE: Refer to “Basics of IP Addresses” on page 42.
2. (Optional) Enter a new value for the Public IP address for port 0. Port 0 is
the external or data port. The Public IP address is the address of the server
nodes on the network.
3. (Optional) For port 0, enter the value for netmask.
Step B. Saving the Configuration
After entering changes, click Save . You are asked if you want to reboot
immediately or wait until later. (You might want to check some values or status
before rebooting.)
NOTE: Changes do not take effect until you reboot through this
software.