Grass Valley Network Attached Storage System Serial ATA Network User Guide v.1.0.04 - Manual (Page 162)

Replacing a Drive
Digital News Production 161
2. If the drive is listed, disable it by clicking on “ here ”. (If the drive is not
listed, NewsShare NAS disabled it.)
Physically, the light on the front of the drive changes from green to blue.
Return to the Logical/Physical View window to confirm that the drive has
been disabled.The drive must be disabled before you remove it.
To remove a drive, do the following:
1. Grasp the release lever with your thumb and index finger and pull outward
to open the door, as shown.
2. Carefully slide the drive out until it is free and out of its bay.
3. Return to the Logical/Physical view window. Verify that the drive is absent.
To insert a drive, do the following:
1. Make sure the drive is seated in the shuttle. Insert the replacement drive
assembly into the empty bay.
2. Press the release lever down and into place.
3. Allow time for NewsShare NAS to spin the disk up. This may take as long
as a minute.