Grass Valley Network Attached Storage System Serial ATA Network User Guide v.1.0.04 - Manual (Page 159)

Chapter 11 Field Replaceable Units (FRUs)
158 Digital News Production
Remove Power
Once the server node is shut down (or if it failed and NewsShare NAS cannot
recognize it), remove power to the node. Do the following:
1. Remove the front panel of the server node you are replacing.
2. Press the On/Off power switch.
3. Make sure that the power LED for the server node is off.
Unplug Cables
1. Unplug the electrical cable from the back of the server node.
2. Unplug the Ethernet crossover cable that connects the two server nodes.
3. Unplug the Ethernet cable that connects the server node to the network
switch.
4. Unplug the optical Fibre Channel cable that connects the server node to the
RAID array.
2982a
Power LED
Server node signal lights
On/Off Switch
Front Panel