Grass Valley JEP-100 v.1.2.0 - Manual (Page 69)

JEP-100 — Installation and Operating Manual 67
Operation
ELAN - Ethernet Mode On/Off
Ethernet mode enables communication through a LAN cable connec tion
(as shown on
page 42 ). The ELAN OFF setting enables communication
through a serial connection.
When a LAN + Serial arrangement is used the panel will normally be oper-
ated in the Serial mode; however, during software upgrades the Ethernet
mode must be used.
Note When switching between Serial and LAN modes, multiple startup messages
may be seen momentarily.
D.T. - Display Time On/Off
In this mode, the time of day (HH:MM:SS) is displayed in the Level
window. The source of this clock is the CM-4000.
Note The clock is synchronized with the CM-4000 approximately every 10 min-
utes.
Chg ID - Change Panel ID Mode
The panel ID is used to identify an individual panel on the Jupiter MPK
Devices table.
When "Chg Id?" is displayed, press TAKE; the Name of the panel (as
created on the Jupiter MPK Devices table) will be displayed in the Level
window. Then use UP/DOWN to select the desired ID in the Preset
window.
In Serial mode, the ID can range from 1 to 16; in Ethernet mode the ID can
range from 1 to 64. When the desired ID is shown, press and hold the "24"
button and press TAKE to apply the change. You should see the panel
restart.
Note The panel ID can also be changed on the IP configuration (web) page, where
it is referred to as the "Device Number" (see
page 30 ). On the MPK Devices
table the panel ID is called "Address" (see page 43 and page 43 ).
v - Version Number Display
Displays the panel software version. Exit with TAKE.
Internet Protocol Address Display
Displays the IP address for reference. The address can be changed us ing
the web page (as described on
page 29 ). Exit with TAKE or CLEAR.