Grass Valley JEP-100 v.1.2.0 - Manual (Page 53)

JEP-100 — Installation and Operating Manual 51
Operation
Button-per-Level Mode Breakaway
This method assumes that the levels have been assigned to specific buttons;
if not see "Defining a Level Button" on
page 55 or "Alternate Mode" on
page 63 .)
1. LEVEL - ON.
Note In this mode, when using a subset of the 96 buttons on the left side of the
panel, the LEVEL button must always be ON for the Level but tons to be effec-
tive.
2. Toggle on/off the desired level(s).
3. Select the desired input:
–Press one of the button-per-source (BPS) keys on the left side of the
panel (which immediately completes the switch), or
–Toggle the SOURCE button ON and use the UP/DOWN buttons to
find a source in the Preset window. Press TAKE to complete the
switch. Toggling SOURCE to OFF will exit.
As long as LEVEL is ON, the panel will remember the breakaway level(s)
previously selected and switch accordingly. When LEVEL is OFF, the panel
will revert to All Level switching.
Checking Status of Selected Level
Press CLEAR. With the LEVEL button ON, press UP/DOWN to step to the
desired level. The status of the selected level with be shown in the Status
window.