Grass Valley JEP-100 v.1.2.0 - Manual (Page 66)

64 JEP-100 — Installation and Operating Manual
Section 1 — JEP-100 Control Panel
6. Press TAKE to complete the switch on the selected level(s).
SelAMod. - Select Audio Mode (Special Stereo Switching)
The JEP-100 can provide stereo switching modes, which are Normal, Left,
Right, Mix, and Reverse. These changes are made to individual levels prior
to completing a switch.
Note Audio mode will only appear in the Preset window if a Venus or Apex router
is connected and configured for special stereo switching. In particular, the
Jupiter Switcher Description table must define Left and Right levels in the
Audio column. For more information, refer to the Jupiter CM-4000 manual.
To perform a special stereo switch:
1. SOURCE - ON.
2. Use the UP/DOWN buttons to select the new input.
3. Press MENU.
4. Use UP/DOWN to display "SelAMod?" meaning that this is the mode
that will be selected if TAKE is pressed.
5. Press TAKE.
The Preset window will display "Pair 1," referring to the first two audio
levels listed in the Jupiter CP Level Set; e.g., Left and Right.
6. If this is the desired pair, press TAKE. If not, use UP/DOWN to select
the appropriate audio pair, and then press TAKE.
The current audio mode for the selected pair will be shown.
A maximum of four audio pairs can be defined.
7. Toggle to the desired mode: