Destination selection / status check – Grass Valley JEP-100 v.1.2.0 User Manual
Page 50
48
JEP-100 — Installation and Operating Manual
Section 1 — JEP-100 Control Panel
Destination Selection / Status Check
To select a destination prior to making a switch or to check status:
1.
ASSIGN/SELECT button - ON.
2.
DEST button - ON.
3.
Select a new destination by using the UP and DOWN arrows to scroll
through all destinations.
When using the UP/DOWN buttons, scrolling past the end of the list
will wrap around to the other end.
It is also possible to program one or more buttons to control outputs
directly. See
.
4.
When the desired destination is displayed in the Destination window,
press the TAKE button to select it.
The name of the input currently switched to this destination will be
shown in the Status window.
Note
If panel "A" does not have access to a certain input, but that input has been
selected by panel "B" for the output presently being statused by panel A, then
panel A has no way of reporting the mnemonic of the input. Under these con-
ditions, panel A will show asterisks (****) for status.
Note
If the panel cannot be changed to the desired output, it may have been limited
to certain outputs by the CP Output set used on the MPK Devices table. See