Defining a source button, Preset - on, Repeat if necessary to find a suitable location – Grass Valley JEP-100 v.1.2.0 User Manual
Page 54: Preset - off, Assign/select - on, Source - on
52
JEP-100 — Installation and Operating Manual
Section 1 — JEP-100 Control Panel
Defining a Source Button
By default, the 96 keys on left side of the panel are assigned to Entry
numbers 0 through 95 listed in the the CP Input set table.
See
.
Figure 20.
Button "1" (the first button) is always equivalent to Entry 0, which in this
example maps to BARS. Buttons can also be programmed from the front
panel using the ASSIGN/SELECT key, as follows:
1.
Press CLEAR.
This returns the panel to the "home state."
2.
(Optional) Check the desired key position for the new input:
a.
PRESET - ON.
b.
Press the key you would like to use. Check the Preset window for
the current assignment.
c.
Repeat if necessary to find a suitable location.
d.
PRESET - OFF.
3.
ASSIGN/SELECT - ON
4.
SOURCE - ON.
5.
Use the UP/DOWN buttons to select the new input.
The name of the new input is shown in the Preset window.
0
8536_21
BARS
1
TONE
1
2
2
TC
3
VTO1
3
4
4
BARS
5
TONE
5
6
6
TC
7
VTO1
7
8
Entry
JEP64
ES LAN
64
JEP65
Serial
65
Input
Logical
Input Set - JEP