Grass Valley JEP-100 v.1.2.0 User Manual
Page 32
30
JEP-100 — Installation and Operating Manual
Section 1 — JEP-100 Control Panel
d.
Gateway - not used in a simple network environment.
If the JEP-100 and the CM-4000 are on separate networks, the
gateway connecting them must be specified.
6.
ES Control Panel Configuration:
a.
Protocol Type:
For a LAN only system (as shown on
): select "LAN."
For a Serial system (
): select "Serial" for normal operation of
panel. Select "LAN" only during the software upgrade pro cess.
For a LAN + Serial system (
): For panels always operated in
LAN mode, select "LAN." For panels normally operated in Se rial
mode, select "Serial" (select "LAN" only during the software
upgrade process).
Note that this selection is identical to the "ELAN on" setting ac
cessed with the front-panel MENU button.
b.
Device Number:
LAN only system: enter a number from 1 to 64. This number must
be unique on this LAN (e.g., unique on network 192.168.253.x).
Serial system: enter a number from 1 to 16. This number must be
unique on the CM-4000 serial bus being used.
LAN + Serial system: for panels always operated in LAN mode,
enter a number from 1 to 64. For panels normally operated in Se rial
mode, enter a number from 1 to 16; this number must be unique on
the CM-4000 serial bus being used.
Note that the Device Number is referred to as the "ID" within the
JEP-100 MENU system and as the "Address" on the Jupiter MPK
Devices table.
c.
ES-LAN Host ID Address: enter the IP address of the CM-4000
associated with this panel.
d.
Secondary Host ID Address: enter the IP address of the redundant
CM-4000 (if any).
7.
Select Submit.
This will apply the settings and reboot the JEP-100.
Note
Once the JEP-100 reboots the panel may (depending on the address used)
no longer be visible from the PC. To return to the page, enter the new IP
address in the browser's URL window.
8.
Go to the next JEP-100 and repeat steps 1 through 7 above.
9.
When finished, restore the file server PC to the original IP settings.
10.
Proceed to the panel configuration instructions in the following section.