Grass Valley JEP-100 v.1.2.0 - Manual (Page 68)

66 JEP-100 — Installation and Operating Manual
Section 1 — JEP-100 Control Panel
S.M. - Sticky Level Mode On/Off
This function allows breakaway operation during which the selected
Levels remain selected after a TAKE. For example, you may want to keep
switching different video test signals to a destination but not switch audio
tone. To turn on sticky mode:
1. MENU - ON.
2. Use UP/DOWN to step to "S.M. on?"
3. Press TAKE. Sticky mode is now active.
4. Perform a breakaway switch (see page 50 ) .
The breakaway pattern of this switch will remain in effect after the
TAKE is executed (and also if CLEAR is selected).
For example, if Sticky mode is on, and the operator makes a vid eo-only
switch, the next switch will also be video only unless spe cified other-
wise. In other words, as long as Sticky mode is on the last-selected
breakaway settings will persist.
To find out which levels are sticky, press LEVEL, then UP/DOWN. The
Level window will show the levels that will switch. If Level but tons have
been assigned, the appropriate buttons will illuminate.
To cancel sticky levels, press MENU, then use UP/DOWN to toggle the
display to "S.M off?" Then press TAKE.
M.O. - Multiple Output Mode On/Off
This function allows "gang" switching where the same input is switched to
multiple outputs with a single TAKE. The following pro cedure assumes
that destination buttons have been assigned (see
page 54 ).
To turn on Multiple Output mode:
1. MENU - ON.
2. Use UP/DOWN to step to "M.O. on?"
3. Press TAKE. Multiple Output mode is now active.
4. Toggle on/off the outputs that you want to switch.
5. Select the desired input.
6. Press TAKE. The input will be switched to all selected outputs.
The breakaway pattern of subsequent switches will remain in ef fect
after the TAKE is executed (and also if CLEAR is selected).
To cancel multiple output mode press MENU, then use UP/DOWN to
toggle the display to "M.O. off?" Then press TAKE.