Grass Valley JEP-100 v.1.2.0 - Manual (Page 18)

16 JEP-100 — Installation and Operating Manual
Section 1 — JEP-100 Control Panel
Space has been provided for adhesive strips to be placed on the front
surface for identification of buttons as they are arranged for specific
projects.
The JEP-100 control panel is designed for use with either a Jupiter CM-4000
System Controller or an Encore Control System.
Note At present the JEP-100 can only be used with Jupiter CM-4000 Sys tem Con-
trollers.
Note The CM-4000 must be operating with Jupiter / Saturn / AccuSwitch version
7.3.2 to support the JEP-100 1.1.1 feature set (except Salvo. JEP-100 salvo
requires Jupiter version 7.4 software).
Note The JEP-100 is not intended for use with Jupiter VM-3000 System Control-
lers.
In Jupiter applications, the JEP-100 can be connected to the CM-4000
System Controller via a 115k Baud serial bus (maximum distance of 2000
feet); or via a Cat 5 Ethernet connection (maximum distance per segment
329 feet). An Ethernet connection is required for software upgrade pur-
poses.
Specifications
Physical Dimensions: 2 RU rack mount: 19 in. W x 3.5 in. H x approx. 4 in.
D (483 mm W x 89 mm H x 102 mm D)
Weight: 2.25 lb. (1.02 kg.)
Operating voltage: 90 to 260 VAC
Operating current: 0.4 A @ 240 VAC or 0.65 A @ 120 VAC
Inrush current rating: 7.9 A
Power consumption: <100 W
Joystick override: Connector, 15-pin D, female.
Wiring between rear-panel connector and customer-supplied contact
closure device: minimum 22 AWG (American Wire Gauge); maximum
length, 30 feet (10 meters).