Grass Valley JEP Series v.1.3.0 - Manual (Page 85)

JEP Series — Installation Manual 85
Figure 42. Password settings of the MPLK Table
2. Enter the preferred setting in the Password Level column ( Figure 42 ):
• Enter a number from 1 to 89 to disable both the Configuration and
Setup menus.
• Enter a number from 90 to 94 to disable only the Setup menu.
• Enter a number 95 and higher to enable both menus.
Note If the Password Level column is left blank, both menus will be accessible.
In the example shown in Figure 42 a password level of 75 and 92 have been
entered.
3. Apply the changes by compiling the appropriate sets and then activate
the sets using the control center.
• For more information about applying changes in Jupiter see the
Jupiter CM-4000 or CM-4400 manuals
Disabling the Configuration and Setup Menus
The Control panels buttons may be disabled. Any button can be configured
to be unassigned for an input or output (Blank Buttons), which may be
used as a separator.
You will need to set the mnemonic for a source or destination to be
“BLANK.” The panel will then disable the button for that source or desti-
nation.
Follow these steps to disable the buttons for a Source or Destination on the
Control panel:
1. Open the Switcher Output table.
2. Enter the text, “BLANK” in the Logical Output Name column
3. Open the CP Output table.
4. Enter the text, “BLANK” in the mnemonic column (see Figure 43 ).
JEP1 CPESXTND 01
JEP2 CPESXTND 02
1
MPK Devices
MPK
Expansion
Pass
Board
CM1
Port Address Input Sets Output Sets Level Set Overide Set Sequence Set
2 CM1 KXYZINP KXYZOUT KXYZLEV
Devices word
In Panel Out Panel
JEP64 CPESXTND 64 64 CM1 KXYZINP KXYZOUT KXYZLEV
KXYZINP KXYZOUT K KXYZLEV
Type
Device
75
92