Grass Valley JEP Series v.1.3.0 - Manual (Page 68)

68 JEP Series — Installation Manual
Section 2 — JEP-100 CP Operation
Defining a Destination Button
Any group of the "96 buttons" can be assigned to individual outputs for "X-
Y" style switching where the operator first selects an output button and
then completes the switch by selecting an input button.
1. Press CLEAR.
This returns the panel to the "home state."
2. (Optional) Check the preferred key position for the output:
a. PRESET - ON.
b. Press the key you would like to use. Check the Preset window for
the current assignment.
c. Repeat if necessary to find a suitable location.
d. PRESET - OFF.
3. ASSIGN/SELECT - ON
4. DEST - ON.
5. Use the UP/DOWN buttons to select the new output.
The name of the new output is shown in the Preset window.
6. Press the preferred button.
The output is now assigned to the button.
The top six function buttons on the right side of the panel can also be used
for destinations but only when Alternate mode is active.
Note A destination button assignment always refers to an Entry number in the CP
Output Set table. If the table is changed such that the Entry number points to
a different Logical Output, the destination button will now select the new
Logical Output.