Grass Valley JEP Series v.1.3.0 - Manual (Page 82)

82 JEP Series — Installation Manual
Section 2 — JEP-100 CP Operation
ELAN - Ethernet Mode On/Off
Ethernet mode enables communication through a LAN cable connection.
The ELAN OFF setting enables communication through a serial connec-
tion.
Note This feature is disabled if the password in the MPK Devices table is 1-95.
When a LAN + Serial arrangement is used the panel will normally be oper-
ated in the Serial mode; however, during software upgrades the Ethernet
mode must be used.
Note When switching between Serial and LAN modes, multiple startup messages
may be seen momentarily.
D.T. - Display Time On/Off
In this mode, the time of day (HH:MM:SS) is displayed in the Level
window. The source of this clock is the CM-4000
or CM-4400 . The clock is
synchronized with the CM-4000 or CM-4400 approximately every 10 min-
utes.
Chg ID - Change Panel ID Mode
The panel ID is used to identify an individual panel on the Jupiter MPK
Devices table if the password entered in the MPK Devices table is set high
enough.
When "Chg Id?" is displayed, press the TAKE button; the Name of the panel
(as created on the Jupiter MPK Devices table) will be displayed in the Level
window. Then use
UP/DOWN to select the preferred ID in the Preset window.
In Serial mode, the ID can range from 1 to 16; in Ethernet mode the ID can
range from 1 to 64. When the preferred ID is shown, press and hold the "24"
button and press TAKE to apply the change. You should see the panel
restart.
Note The panel ID can also be changed on the IP configuration (web) page, where
it is referred to as the Device Number. The panel ID is called “Address” on the
MPK Devices table.
v - Version Number Display
Displays the panel software version. Exit by pressing the TAKE buttons.
Internet Protocol Address Display
Displays the IP address for reference. The address can be changed using the
web page. Exit by pressing the
TAKE or CLEAR buttons.