Grass Valley JEP Series v.1.3.0 - Manual (Page 71)

JEP Series — Installation Manual 71
Salvo Switching
Note The JEP-100 Salvo function requires Jupiter version 7.4 software (or newer)
to be operating in the CM-4000.
The SALVO key can be used to execute a list of pre-built Jupiter sequences,
where a sequence is a switch of one or more sources to one or more destina-
tions.
Setting Up a Sequence
A Jupiter sequence is built using the Jupiter Sequence Set table, an
example of which is shown
Figure 36. Example of Jupiter Sequence Set table
The sequence set is given an eight-character (max) name and is of type
"3800."
In this example, sequence set "SETUP" contain two sequences: "SET UP1"
and "SETUP2." "SETUP1" will switch Cameras 1 through 3 into Monitors 1
through 3 (a total of three switches) with a single TAKE command.
"SETUP2" will reverse the order of the cameras in the monitors. Each
sequence can include up to 25 events (switches).
There is no specific limit to the number of sequences, but due to memory
restrictions a limit of 16 is recommended (e.g., "SETUP1" through
"SETUP16."
The sequence set must be assigned to the JEP-100 panel on the Jupiter MPK
Devices
table.
For additional information regarding Jupiter sequences and assigning
them to control panels, refer to the CM-4000 or CM-4400 manual.
1
Sequence Set - SETUP
Sequence
SETUP1
Input
CAM1
Levels
YYYY
2
3
4
SETUP1 CAM2 YYYY
SETUP1 CAM3 YYYY
SETUP2 CAM1 YYYY
Output
MON1
MON2
MON3
MON3
...
...
...
...
Logical Logical
5
6
SETUP2 CAM2 YYYY
SETUP2 CAM3 YYYY
MON2
MON1
...
...
071_
8
536_02_seq-ta
b
le