Grass Valley JEP Series v.1.3.0 - Manual (Page 62)

62 JEP Series — Installation Manual
Section 2 — JEP-100 CP Operation
Show Button Assignment
The 96 keys on the left side of the panel can be assigned to inputs, outputs,
levels, and salvos. To check button assignments, press PRE SET and one of
the "96 keys;" the name of the in/output, level, or salvo assigned to the key
will be displayed in the Preset window. No actual switching takes place
during this procedure.
Destination Selection / Status Check
To select a destination prior to making a switch or to check status:
1. ASSIGN/SELECT button - ON.
2. DEST button - ON.
3. Select a new destination by using the UP and DOWN arrows to scroll
through all destinations.
When using the UP/DOWN buttons, scrolling past the end of the list will
wrap around to the other end.
It is also possible to program one or more buttons to control outputs
directly.
4. When the preferred destination is displayed in the Destination window,
press the
TAKE button to select it.
The name of the input currently switched to this destination will be
shown in the Status window.
Note If panel "A" does not have access to a certain input, but that input has been
selected by panel "B" for the output presently being statused by panel A, then
panel A has no way of reporting the mnemonic of the input. Under these con-
ditions, panel A will show asterisks (****) for status.
Note If the panel cannot be changed to the preferred output, it may have been
limited to certain outputs by the CP Output set used on the MPK De vices
table.