Grass Valley JEP Series v.1.3.0 - Manual (Page 38)

38 JEP Series — Installation Manual
Section 1 — JEP-100 Control Panel
Updating to the Latest Software Version
Versions 1.2.0 and earlier used the Network Download Utility to update
software. Follow this process for converting the panels to work with Net-
Config.
NetConfig is used to update panels for versions after 1.3.0.
The update process will use three applications: the Download Manager
and the Update Manager. You will then use NetConfig.
All of these programs are installed with the JEP-100 panel software instal-
lation.
You will need to know the IP address and Device ID of the hardware that
will be associated with the JEP-100. Grass Valley recommends that you
identify and write down the Device IDs and IP Address for the current
panels before you start the update process.
Using the Network Download Utility
This step you will download the new firmware to the panel using the
Network Download Utility.
Follow these steps to load the software onto the panels:
1. Start the Network Download Utility application. (Start>All Programs
>Grass Valley>Jep100 >DownloadManager) Any JEP-100 panels with
1.2.0 on the network should be displayed
Leave the RAM Loader and User Program fields with their default settings,
these are the correct files.