Grass Valley JEP Series v.1.3.0 - Manual (Page 56)

56 JEP Series — Installation Manual
Section 1 — JEP-100 Control Panel
LAN + Serial System
The example shown in Figure 31 is of a system where one or more JEP-100s
will normally be operated in Serial mode, while other JEP-100s are always
operated in LAN mode.
The JEP-100(s) operated in Serial mode will require a LAN connection only
during a software upgrade session.
Figure 31. Example of LAN + serial system naming and addressing
Serial Protocol Table Entries
When a JEP-100 is connected to a CM-4000 or CM-4400 serial port (and
operated in Serial mode), the panel must be configured for “ESCP” protocol
using the Serial Protocol table. The Baud rate should be set at 115K. Panels
Serial bus
Serial
Ports
100baseT Jupi
ter LAN
16 JEP-100s per
serial bus maximum
IP switch
64 LAN-operated
JEP-100s per CM
maximum
Panel ID
02"
Panel ID
01"
Panel ID
64"
Panel ID
01"
upiter
ile Server
CM-4000/4400 System Controller
CM1"
JEP1"
JEP2"
JEP64"
JEP65"
_