Grass Valley JEP Series v.1.3.0 - Manual (Page 24)

24 JEP Series — Installation Manual
Section 1 — JEP-100 Control Panel
Space has been provided for adhesive strips to be placed on the front
surface for identification of buttons as they are arranged for specific proj-
ects.
The JEP-100 control panel is only designed for use with either a Jupiter CM-
4000, CM-4400 System Controller, or an Encore Control System. The JEP-
100 panel is not intended for use with Jupiter VM-3000 System Controllers.
Note The CM-4000/4400 must be operating with Jupiter / AccuSwitch version
7.9.1 to support the JEP-100 1.3.0 feature set.
Note The CM-4000/4400 must be operating with Jupiter / Saturn / AccuSwitch
version 7.3.2 to support the JEP-100 1.1.1 feature set (except Salvo. JEP-100
salvo requires Jupiter version 7.4 software).
In Jupiter applications, the JEP-100 can be connected to the CM-4000/4400
System Controller via a 115k Baud serial bus (maximum distance of 2000
feet); or via a Cat 5 Ethernet connection (maximum distance per segment
329 feet). An Ethernet connection is required for software upgrade pur-
poses.
Specifications
Physical Dimensions: 2 RU rack mount: 19 in. Width x 3.5 in. Height x
approx. 4 in. Depth (483 mm W x 89 mm H x 102 mm D)
Weight: 2.25 lb. (1.02 kg.)
Operating voltage: 90 to 260 VAC
Operating current: 0.4 A @ 240 VAC or 0.65 A @ 120 VAC
Inrush current rating: 7.9 A
Power consumption: <100 W
Joystick override: Connector, 15-pin D, female.
The wiring between the rear-panel connector and a customer-supplied
contact closure device: minimum 22 AWG (American Wire Gauge);
maximum length, 30 feet (10 meters).