Grass Valley JEP Series v.1.3.0 - Manual (Page 63)

JEP Series — Installation Manual 63
Source Selection (All Levels Take)
Figure 34.
1. The PRESET and LEVEL buttons should be OFF.
2. Select the preferred input:
• Press one of the button-per-source (BPS) keys on the left side of the
panel (which immediately completes the switch), or
• When the SOURCE button is ON , the UP/DOWN buttons can be used
to find a source in the Preset window. Press the TAKE button to com-
plete the switch.
The newly switched source will be shown in the Status window.
If a BPS button was used to select the source (or if a BPS button corre-
sponds to the selected source) the button will illuminate. However, the
button will not illuminate if the first level assigned to the panel on the
Level set table has been set to "No" switching. Nor will it illuminate
unless all levels assigned to the button are switched.
BPS button programming
The BPS button assignments are based on the entries to the CP Input table
but these assignments can be changed using the panel itself.
It is also possible to assign these buttons to a destination or to levels.
Destination
Status
Preset
Level
8536_07
Button-per-source keys